Heat and Massage Installation:

The connection box mounts with one screw in any of three holes on each side to the inside of the seat frame.
The seat frame wood may have upholstery or black fabric covering it.
Mount the connection box on the right hand side of the chair where the pocket is and the up and down control is.
The RCA jack style end of the wire for the power supply connection can be mounted on the bottom right inside of the chair frame.

You will have to make a slit in the backing on the inside of the lumbar area to slide your hands in
and slip the heating pad between the stuffing and the lumbar area upholstery. Have the power wire
coming out the right side (same side as hand control and the side you mount the connection box on.
The three wires coming from the back, (2 vibrators and 1 heating pad wire), can be wound together and zip
tied into an appropriate length bundle so they do not hang down too much and have enough length to plug into
the connection box.

Zip tie the vibrators to the springs over the white rods.  One in the upper back, one in the lower lumbar back, and
one in the middle of the seat. The back velcros at the bottom. Undo it and lift it up to access the back springs. Make sure foam padding is placed between springs and vibrators to dampen the noise. Connection to the white rod that ties the springs together will help the vibrator vibrate more area.